• Corrects factory ride height sensor positioning
• Adjustable 125–135 mm
• Works with factory ride height sensors
• Required for any front lift over 1.5" on the 2027 Ram TRX and 2025-2026 Ram RHO
• Works with Foutz Motorsports 2" and 2.5" TRX and RHO lift collar kits
• Sold as a pair

• Ram 1500 TRX: 2027
• Ram 1500 RHO: 2025, 2026
• Works with TRX & RHO Foutz Motorsports Lift Collar kits

• (2) Adjustable ride height sensor connector rods

Starting Rod Length by Collar Height

• 1.5" collar: 132 mm
• 2.0" collar: 129 mm
• 2.5" collar: 126 mm

Print the connector rod settings sheet at 1:1 scale and use the images on the document as a quick reference for setting the adjustable connector rod length.

Which trucks need ride height connector rods?

The 2027 Ram TRX and the 2025-2026 Ram RHO need them for any front lift over 1.5". The ride height sensor location has to be corrected at that height. The 2021-2024 Ram TRX does not need them; the factory ride height sensor rod does not have to be changed to lift those trucks.

How do I set the starting length?

Use the starting length for your collar height in the settings panel above, or print the 1:1 settings sheet and match the rods to the images. Before installing, measure the sensor arm angle or mark its position with the truck sitting at ride height.

Why may the final length need adjustment?

Each truck can sit differently, so the listed length is a starting point.

Should both ends be adjusted evenly?

Yes, to maintain equal thread engagement.

Why check the sensor position after installation?

The suspension should be settled before making the final adjustment. Roll the truck back and forth, check the sensor arm against your mark, adjust if needed, then tighten the jam nuts.

What is the adjustment range?

125–135 mm. Do not exceed this range.