• Reinforce and stabilize front lower control arm (LCA) alignment
• Strengthen the weak point in the rear mounts of the LCA
• Prevent the LCA rear mounts from bending on hard hits

The front lower control arm pivots on a front mount and a rear mount. When a front wheel hits something hard, such as a rock or a square-edged hole, the load drives the wheel back and up, and much of that force ends up at the rear pivot mount.

That rear mount is the weak point. If it bends, the lower arm no longer sits where the alignment was set, and the truck can pull, wander or wear the front tires unevenly. Reinforcing the mount keeps the arm located where it belongs, hit after hit.

The brackets are MIG welded for extra strength and powder coated in a textured hammer black finish.

Fits the 2017–2020 Gen 2 Ford F-150 Raptor.

Works with the stock lower arm or the FMI fabricated lower control arm.

Works with the stock sway bar or the FMI upgraded sway bar kit.

Bolt-on and easy to install. No modifications are needed, and the kit uses the factory hardware.

After installation: get your Raptor realigned once the brackets are installed, so you do not end up with poor tire wear on the front.

What problem do these brackets solve?

The rear mount of the front lower arm is prone to bending under heavy front wheel impacts. The brackets strengthen that mount so it holds its shape and the alignment stays put.

Do I need to modify anything to install them?

No. It is a bolt-on kit that uses the factory hardware.

Do I need an alignment afterwards?

Yes. Get the truck realigned once the brackets are installed to avoid poor front tire wear.

Which lower arms do they work with?

They work with the stock lower arm or the FMI fabricated lower control arm.

Will they work with my sway bar?

Yes. They work with the stock sway bar or the FMI upgraded sway bar kit.

What finish are they?

Textured hammer black powder coat over MIG welded brackets.