• 2 rear large panels
• 2 front square panels
• 4 bed wall mount cleat brackets
• 2 corner support mounts for the rear tie-down location
• 1 hardware kit: 24 stainless carriage bolts and nuts

The bed walls are the largest flat surfaces on the truck, and from the factory they offer only a few tie-down points. Anything you strap to the floor competes with your cargo, and anything you leave loose moves every time the truck does.

Covering the walls with a grid turns that area into mounting surface. The panels go over the cleat area for the most square feet of mounting space, and the grid inserts let you change your load-out whenever your plans change.

• .135" thick 1018 steel panels
• Bed wall mounts made from the same .135" steel, precision bent to fit the truck
• Grid design with custom Adapt-A-Panel grid inserts for mounting a variety of gear and accessories, even heavy items like power tanks and high-lift jacks. Inserts can be added any time after install.
• Textured hammer black powder coat so the panels blend into the bed rather than draw attention
• Black stainless hardware for a clean look once installed

Product protected by US Patent No. 11,940,092 and US Patent No. 12,276,377.

Fits the 2024–2026 Ford F-150 Raptor and the 2024–2026 Ford F-150 with the 5.5 ft bed.

The panels attach quickly to existing hardware locations in the bed using the included hardware kit.

Does it fit a standard F-150?

Yes, 2024–2026 F-150s with the 5.5 ft bed, the same bed as the Raptor.

How many panels are in the kit?

Four: two large rear panels and two square front panels, with four bed wall cleat brackets and two corner supports at the rear tie-down location.

How does it mount?

The kit attaches to existing hardware locations with the included hardware.

Can it carry heavy gear?

Yes. With the Adapt-A-Panel grid inserts you can mount heavy items like power tanks and high-lift jacks. The panels and bed wall mounts are .135" thick steel.

Can I change my setup later?

Yes. Grid inserts can be added any time after install, so you can change your load-out for the trip.

What finish is it?

Textured hammer black powder coat with black stainless hardware.

Is it patented?

Yes. The product is protected by US Patent No. 11,940,092 and US Patent No. 12,276,377.