This light bar is awesome. I was able to put 2 XL80s, 7 Squad Pros, and 2 S2s on mine. There is still plenty of room to get the allen key in there to adjust the vertical aiming on each light. There is also room to add BD’s light leveling motor later, which is something I may do later. One of my initial questions was if I would have access to tighten or replace a light without removing the bumper. The answer is yes to all of them except when the mounting brace is located (XL80s on my setup). There is no drilling necessary, so you can return to stock without any marks if desired. You do have to remove the stock bumper to install, but that’s not bad once you understand how it’s attached. Recommend installing all your lights and wiring the light bar off the bumper before taking apart your truck. Make the harnesses is sections and leave the wiring long until everything is attached to your vehicle. As usual Johnny Yackle was very helpful in getting this ordered and delivered promptly. Highly recommend Foutz products and Apollo sales and service!
